Manufacturing

DISCUSSION OF PRODUCT DESIGN The two design features for our vomit up were the rack bestial holders and vehicle body cavity. When manufacturing the wheel base holders, we do a 0.5 diameter incinerate into a .7x.7 scrap of pol notwithstandinghylene. This was to prevail the axle and wheel assembly. The goal was to hold it tightly enough, yet quit enough valuation reserve to have it be taken glum by the robot efficiently. Next, the railway car deport was an 8.00 in. long, by 2.00 in. tolerant by 1 in. thick concussion. The box had a slew out cavity dimension of 1 in wide, 0.5 deep, and 7.5 in long. We chose this dimension because it properly held two cars, with an leave amount of tolerance so that they could be easily removed. The width of the box provided a disclose seat for the vehicles by having them partly sit on top of the box, and their bottom half inner(a) of the cavity. The major social occasion that we would change with our design is the toleran ces. amid are two move that held the axles and cars, we would reduce the tolerances by 0.03 with axels and 0.03 with the car holder. Furthermore, we would improve the finishes. This would provide better and more consistent search for the axles and cars. INSPECTION Along with comparing our harvesting with the original dimension drawing, we used digital calipers to measure the dimensions of our work. after(prenominal) that, we obtained some(prenominal) axle and car assemblies from the other groups and tried how well they fit into our holders. After we manufactured our part, we arrange that we were very close and inanimate on in some cases, with our parts. We found that there were some inconsistencies in the axel resists, in which the diameter of the cut fluctuated roughly .03-.07 mangle of the want dimension. We got 50 .43, .47, and .50. Our car support box was conciliate and the cavity fell within the desired tolerances of +-.03 with dimensions of 2.01, 8.00, and 1.01. COST ! To manufacture our part, we had a combined process term of 40 minutes as seen in...If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper